Originally Posted by Track Junky (Post 410870)

What duration at .050 are you running? Whats lobe center and installed center?

Originally Posted by Track Junky (Post 410903)

LOL. yeah right....like your the only guy that has built a big block with power in a specific range. :lol:

Although, I dont think I'd give up my specs either. :)

Originally Posted by Vegas69 (Post 409470)

You ain't playin...:D

The only thing I'd say is that cam is a little knarly for low rpm cruising in overdrive. I run a 252/260 @ .050. 110 LSA Good low end torque but it pulls to 6800 no problemo. Peak power at 6200.

Originally Posted by FETorino (Post 410947)

It's no secret he already gave up the secret. :D He figured if he said it in the middle of a Ford thread nobody would pay attention. :rolleyes:

Originally Posted by FETorino (Post 410947)

It's no secret he already gave up the secret. :D He figured if he said it in the middle of a Ford thread nobody would pay attention. :rolleyes:

Originally Posted by Flash68 (Post 411037)

I think it was only a secret because Gaetano asked about it. :lol:

Originally Posted by coolwelder62 (Post 411042)

Or,Todd didn't have the cam card handy.:willy:

Originally Posted by coolwelder62 (Post 411042)

Or,Todd didn't have the cam card handy.:willy:

Originally Posted by Flash68 (Post 411044)

Knowing Todd it's likely pinned to this shop wall. Or in his wallet.

Originally Posted by coolwelder62 (Post 411048)

Hasn't Todd changed the cam 2-3 time's.:D