Like this build (rebuild) and has giving me the boot in the ass I need to get more than a few hours a week on my project.

Spent many hours tig welding on the tunnel:
https://i.imgur.com/37WwGAzl.jpg
https://i.imgur.com/xShWwxGl.jpg
https://i.imgur.com/WTCygK7l.jpg
https://i.imgur.com/VY1p2OOl.jpg
https://i.imgur.com/Nc280FMl.jpg
https://i.imgur.com/G12kvGDl.jpg
https://i.imgur.com/wGrrYIql.jpg
https://i.imgur.com/5TpZo48l.jpg
https://i.imgur.com/GLpcCLCl.jpg
https://i.imgur.com/35L88ZIl.jpg
https://i.imgur.com/XfXYuDIl.jpg
https://i.imgur.com/4iW8F1yl.jpg

Very creative :superhack:

I like the way those crossmember sections taper out.

BTW.....who is the cad designer? I'm ex GM Holden cad guy.

Thanks. I do all the CAD work. I’m a mechanical engineer by trade. And by CAD I mean both computer aided and cardboard aided. This job was all hand fabricated and cutout with a jig saw and angle grinder.

Craig car is looking great! Pm me when you head down to crows as I’ll roll with you.

:RunninDog:Sounds good. I’m going to run Good Guys next weekend and skip AAS. I hope to run one or both days for the LMP AAS event on 7/6 and 7/7.

Are you going to run the Camaro in cam-c?

I'm going to run the Camaro @ AAS this Sunday morning however i'm (50/50) as the Wife is due any day now with baby #3.

I just do fun run because I don't run enough for them to give me a Cam-C number.

If that all falls apart i'll most likely roll over to GG

This--I like the Saturday (7-6). Maybe I can finally get to Crows and make a mess . . .

Are you cam-T, Craig? My car looks pretty "traditional," so it should fit there.

Nice work on the car as usual!

Yes cam-t for me. As long as it has floor coverings and is 3000# or more it should be fine. No floor coverings and or less than 3000# is cam-s.

Good luck with the new baby! I don’t know whether to say “congratulations or you poor bastard” 😀.