Nice project. Keep the pics coming :thumbsup:

Awesome project Tony. This is going to be one sweet ride...

69
 

Thanks for all of the compliments guys.
The core support is in the same spot, I cut it in half then boxed in the sides to move the radiator out about 3/4" to 1". The radiator came from Frank at Prodigy, I had to move the top hose inlet up and in so the hose would clear the inlet hat, I also had to build a little box and lower the filler neck so it would clear the hood and soon to be filler panel. I will get you the inlet hat part # and a phone# to the place I bought it from. I spent $50 sending inlet hats that wouldn't work back. Also looked into the one that Jay Doerfler is using on his build but I found out he was using the smaller blower. I could have moved the motor back a little further but it still would have still been tight.

Very nice Tony. I'm digging it.
Keep us posted please!:cheers:

69
 

I lied, the radiator is moved 2 3/8" out from the stock location.

The inlet hat came from east coast supercharging 606-752-0321. It is for their Paxton SCT600 2007 to 2008 GM truck kit. You can see a picture of it installed on a truck. The picture shows it to be aluminum, I was told that they only make it in plastic but is is a good quality piece.

Thanks.

Do you know if that is a 4" inlet on that F1?

Keep up the good work! This is a great build. :thumbsup:

inlet hat
 

The inside diameter on the inlet hat for a F-1 is 3.75"

Recaro seats
 

Finally got the new seats and harness dummied up.

Very nice.:thumbsup:
What type of center console is that?

Very nice I like those seats.