Lateral-g Forums
Page 3 of 3 12 3
Show 40 post(s) from this thread on one page

Lateral-g Forums (https://www.lateral-g.net/forums/index.php)
-   Transmission and Rear End (https://www.lateral-g.net/forums/forumdisplay.php?f=39)
-   -   Lokar Dip Stick 4L60E (https://www.lateral-g.net/forums/showthread.php?t=24934)

bigtyme1 01-31-2010 08:04 PM
Quote:
Originally Posted by Vegas69 (Post 266306)
Is it leaking at the oring or flare connection?
Can't tell yet, I think it's from the o Ring side.

bigtyme1 01-31-2010 08:11 PM
Tride to pull the AN fitting off and it broke off in the trans. Wanna buy a car cheap!!!!

Vegas69 01-31-2010 08:11 PM
In that case, I'd remove the fittings and make sure the sealing surfaces are flat and clean.

bigtyme1 01-31-2010 08:47 PM
I was able to get it out with a easy out. Lucky!!! there is no o rings, this is a 45 swivel ans it uses a brass bushing. what did I do wrong? I'll get new fittings tomorrow

Vegas69 01-31-2010 08:53 PM
Your fitting doesn't line up with you threads??? The copper sealing washer is not be compressed on either side. Is you fitting tweaked?

bigtyme1 01-31-2010 09:11 PM
I got to go to bed, but I'm glad I got it out ok. I'll call you tomorrow if your not busy. I need to get new fittings anyway. Any suggestions?

79 Camaro 02-11-2010 06:47 PM
Check with the guys Godman fittings. I've used the on my 4L60E/LS1 swaps. Used a liittle teflon sealent paste on the threads just to be sure. Zero problems. Also used Lokar trans dipsticks with zero leaks.

Northeast Rod Run 02-17-2010 09:59 PM
Quote:
Originally Posted by HRBS (Post 266281)
Mark... how long was this trans sitting before you put it in the car and ran it ?
Could be that the front pump seal dried out during storage or may not have been replaced on the rebuild. If its leaking from there it would weep out of the inspection cover and coat the pan with fluid making it look as if it was coming from say the dip stick inlet.
Throw that bad boy on the lift and have someone start it while you look from underneath. That way you're not guessing.
Now, that's thinking with your dipstick Jimmy:unibrow: :lol:


All times are GMT -7. The time now is 08:18 AM.
Page 3 of 3 12 3
Show 40 post(s) from this thread on one page

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2026, vBulletin Solutions Inc.
Copyright Lateral-g.net