Rear frame all finished and wheel tubs done.

http://i55.photobucket.com/albums/g1...alismall70.jpg

Painted the entire underside in a light texture coating.

http://i55.photobucket.com/albums/g1...alismall76.jpg

http://i55.photobucket.com/albums/g1...alismall77.jpg

There's a nice contrast between the two frame and body now.

http://i55.photobucket.com/albums/g1...alismall78.jpg

Gas tank built from scratch with all of the evap stuff from the original tank. We decided to keep everything GM put in the car, that way it's as close to "stock" as possible. We even re-used all of the plastic lines by heating them slightly, bending them and letting them rest in their new form. If you have a lot of patients, it isn't that difficult to do.

http://i55.photobucket.com/albums/g1...alismall73.jpg

http://i55.photobucket.com/albums/g1...alismall74.jpg

http://i55.photobucket.com/albums/g1...alismall75.jpg

Rear pieces back from powdercoat.

http://i55.photobucket.com/albums/g1...alismall72.jpg

http://i55.photobucket.com/albums/g1...alismall79.jpg

Gas tank mounted...

http://i55.photobucket.com/albums/g1...alismall80.jpg

Lots of clean work going into this thing.

What are you using for bearings in the shock rocker arms?

Very nice Robbie. Should be a fun project when complete.:thumbsup:

The shock rockers arms are using bronze oilite bushings from McMaster.

The interior cut up. These were the worse cuts in the whole project for me. I dreaded cutting all of the interior panels and plastic. We've formed a speaker box that comes off of each side and is open down the middle. The speaker box covers up the wheel tub and fits up snug to the factory plastic.

http://i55.photobucket.com/albums/g1...alismall84.jpg

Machined a piece to run all of the wiring through now. You can see the huge hole that was used before. We filled the hole in because we needed the clearance for the tire. We needed a really large hole to fit all of the large plastic plugs through that plug into the fuse box.

http://i55.photobucket.com/albums/g1...alismall86.jpg

Looks good ! Very simple and clean. When I say simple I know it aint easy. :thumbsup:

This build is in Street trucks right? I love that mag... you are doing some nice fab work...:thumbsup:

great work! where will it be parked at sema? i'd love to get an upclose look at it.