Lateral-g Forums - '69 Camaro Front Clip

Lateral-g Forums (https://www.lateral-g.net/forums/index.php)

- Parts for Sale (https://www.lateral-g.net/forums/forumdisplay.php?f=18)

- - '69 Camaro Front Clip (https://www.lateral-g.net/forums/showthread.php?t=29051)

I am starting to get more interest in my other parts and I will post pic's tomorrow but in case anyone is wondering, I no longer need these because I went to an aluminum front clip. Fenders are fixable and I would have reused them if I were to keep the steel front clip.

Fenders are sold!!

Thanks Greg!!

Quote:

Originally Posted by Track Junky (Post 317717)

Wow, thanks for letting me know.

In that case I dont think Doom is going to be interested in paying $500.

Gandalf, if you are still interested I imagine I should be headed toward Buttonwillow Racepark within the next few months.

Let me know.

I just checked some old paper work when I sent some fiberglass fenders to ANVIL $325.00 :faint: Thanx I'll keep lookin!

how did the AMD fenders and clip fit? just saw the stuff at SEMA and if looks real nice-

Quote:

Originally Posted by youthpastor (Post 317913)

how did the AMD fenders and clip fit? just saw the stuff at SEMA and if looks real nice-

I had to ream a few of the holes to make the panels fit together but I was told that is to be expected with after market panels.

I was a little disappointed about the hood. It had a crown in the center and it sat about 3/16ths of an inch above each fender. At the time I had no time to replace it because of a tight schedule to make the Spectre341Challenge.

Other than that I am pretty happy with the end result.

If you choose to go with an aluminum front clip it is important to remember how easy it is to crease thin gauge aluminum. I have leaned on the top of the fenders while working on the engine and put slight creases at tops of fenders leaning on them.

Also, if you dont have full wheel wells small pebbles and tire marbles will hit the underneath of the fender tops and make your fender look like it has pimples on the top.

Here are some pics.
http://i851.photobucket.com/albums/a...6/th_007-1.jpg
http://i851.photobucket.com/albums/a...6/th_006-1.jpg

Not to clutter this thread up but how much weight is saved?

Quote:

Originally Posted by Bow Tie 67 (Post 317926)

Not to clutter this thread up but how much weight is saved?

Its hard to figure exact weight savings with just front clip due to going to an aluminum block at the same time but I figure plus or minus 90 lbs. In total I took 200 lbs off the front of the car.

Quote:

Originally Posted by Track Junky (Post 317928)

Its hard to figure exact weight savings with just front clip due to going to an aluminum block at the same time but I figure plus or minus 90 lbs. In total I took 200 lbs off the front of the car.

Very nice, how much off total weight of car?

Do you still have the upper header panel ? What kind of shape ? Any rust ? Any pics ? How much shipped to 74128 Tulsa Ok.