We have a 5x10 foot table.
It really is the only way to go

Well my machine is finally running. Still tuning and doing a lot of setup to maximize the cutting and the finish. Overall very happy. Here are two generic DXF files I downloaded somewhere off the net late last night to do some test cutting of some more detailed pieces, than squares and circles I have been creating to test cut. Very happy with the outcome. All done at 45 amps, with standard comsumables.

http://www.fletcherscustoms.com/copp...ruckergirl.JPG
http://www.fletcherscustoms.com/copp..._deerprint.JPG

I got a 4x4 torchmate 2 and i love it! I thought about a bigger table but it takes so much space and seriously, cutting a sheet in half is not too bad. It helps loading the piece in there since its smaller and half the weight and i dont always have help. So far so good.