Lateral-g Forums - 9" Case Fitment

Page 3 of 3

Show 40 post(s) from this thread on one page

Lateral-g Forums (https://www.lateral-g.net/forums/index.php)

- Transmission and Rear End (https://www.lateral-g.net/forums/forumdisplay.php?f=39)

- - 9" Case Fitment (https://www.lateral-g.net/forums/showthread.php?t=35170)

intocarss

01-21-2012 06:29 PM

Quote:

Originally Posted by Track Junky (Post 391009)

Coming from a construction back ground I have used my framing hammer and my single jack many many times. And I dont leave to a track event without them.

As long as you don't use nails for cotter pins, We're good :willy:

TheJDMan

01-23-2012 09:22 PM

Do you have a gasket? Does it fit the housing?

Vince@Meanstreets

01-23-2012 11:08 PM

Thats what happens when Engineers start mixing with grease monkeys....have you seen the guys that work and build these for a living??? LOL I kid. Im an ex heavy duty flat rate mech, I can make fun of us.....however back to your issue.

Who installed the studs in the case? If they are crooked or misaligned you will have problems droping in. I always recheck the studs for square before I drop in the chunk. just sayin. p

Vince@Meanstreets

01-23-2012 11:16 PM

1 Attachment(s)

oh just incase you need it...top secret stuff. burn after using please. :P

feeble

02-16-2012 03:51 PM

I am working on a 3D model of a stock early 70s 9" Ford truck housing. Any chance you could post a higher resolution shot of that so I can read the dimensions clearly?

Thx!

All times are GMT -7. The time now is 11:28 AM.

Page 3 of 3

Show 40 post(s) from this thread on one page