That's gonna be one sick ride Jeff. Can't wait to see it done....welcome to the site!

Good Lord, Ron Trexler...now there's a blast from the past...I haven't seen him in ages. Tell him I said hello. I don't know if you remember Brian Rambo but he still pops by my house in the Summer with his Road Runner to have a few beers and reminisce about the old days. Damn we're getting old. :lol: I'm still good friends with Craig and Erik (the twins). But Dennis Perazza (black Cutlass) fell off the face of the earth about 10 years ago. Don't know what he's up to. Actually Erik and I are going to SEMA this year.

I gotta stop by and see this monster your constructing, looks awesome. I'll send you my cell number via Private Message. Check up at the upper right hand corner of this message board where it says "Private Messages".

Good to hear from you online....finally! :thumbsup:

Nice looking project, can't wait to see it done with the LS7 :thumbsup:

ls7 pics
 

We got the engine in last night! I got some pretty good pics. I was going to use the factory exhaust manifolds, but I decided to get headers from street & performance instead. Hopefully will have them in a week or two. Also installed a front mount rack from BRP, now I just have to figure out a sway bar location. I'm thinking something like a speedway front mount. BRP sent the brackets to mount in back, but I think it will hang down to low. Anyway I'm looking for any feed back as I go forward with this thing, if anyone has any suggestions/ideas on anything feel free to voice your opinion.Thanks :thumbsup:

couple more pics
 

a few more

:hail: :hail: :hail: to the LS7 what a sweet motor!

I'd really like to know how the install goes, PCM mods and Throttle By Wire etc.

You should run the Hooker or SW longtubes or better the ATS ones if they fit your budget. :unibrow:

Killer car :thumbsup:

Looks sweet! :thumbsup:

headers
 

The ATS ones definately don't fit the already blown budget. I didn't know Hooker made any. Do you have any info on them?

Here's the info: http://www.holley.com/2288-1HKR.asp

They also make thier own motor plates.