We block sanded the body than sprayed two coats of SPI epoxy

http://img.photobucket.com/albums/v3...ps5c571096.jpg

Brian cleaned the Rod & Custom crossmember getting ready to weld motor mounts.

http://img.photobucket.com/albums/v3...ps471f790d.jpg

Getting ready to test fit the FE block with the Canton pan and TKO 600

http://img.photobucket.com/albums/v3...ps1a88d22f.jpg

Making sure the block is in the center, level and has a 4 degree angle so Brian can weld the motor mounts.

http://img.photobucket.com/albums/v3...psa4583e1c.jpg

The transmission mount had to be modified to get the correct angle.

http://img.photobucket.com/albums/v3...ps8cc76eaa.jpg

http://img.photobucket.com/albums/v3...ps5912c573.jpg

http://img.photobucket.com/albums/v3...ps74bad168.jpg

http://img.photobucket.com/albums/v3...psf3e62907.jpg

Looks great Rusty!
I don't know how I missed this build?!

Brian welded the motor mounts in place. Now when you order a kit from Rod & Custom the motor mounts are already welded.

http://img.photobucket.com/albums/v3...psaa6f3d24.jpg

http://img.photobucket.com/albums/v3...ps0448f28b.jpg

http://img.photobucket.com/albums/v3...ps922743ad.jpg

http://img.photobucket.com/albums/v3...ps036f7df8.jpg

http://img.photobucket.com/albums/v3...psc6d25dee.jpg

The new owner did not like the Eleanor non functional quarter scoops so we cut them off and installed Shelby scoops.

http://img.photobucket.com/albums/v3...ps912f2648.jpg

http://img.photobucket.com/albums/v3...psceb80fd6.jpg

http://img.photobucket.com/albums/v3...ps0484b15b.jpg

Awesome. That is going to look mean and functional.

just found this searching your posts, any updates?

No it is on hold at this time.

This project was on hold for a few years and the owner has decided on a few changes. I'm sorry to say he has decided not to go with the SOHC but is going with an aluminum FE just not sure how big it will be yet. We will also be doing a few modifications to the body.

It is out of storage and back in the fab shop.

http://img.photobucket.com/albums/v3...psfvmv961j.jpg

The first thing Brian did was finish lining up the sheetmetal

http://img.photobucket.com/albums/v3...ps8frpr6hf.jpg

Starting to install the Mustang to Fear gas filler kit.

http://img.photobucket.com/albums/v3...psjytmq8ah.jpg

http://img.photobucket.com/albums/v3...psvnvprfmz.jpg

http://img.photobucket.com/albums/v3...ps6zvywiyb.jpg

Welded in place and the welds ground

http://img.photobucket.com/albums/v3...psd9qx0nws.jpg

http://img.photobucket.com/albums/v3...psimnzcmvn.jpg

Glad to see it's back on. I thought this would make for a cool ride no matter what engine choice. Good luck!