Sounds good to me !

@HPI those tabs for the fuse box are awesome, I'll order some for the next time.

If I could make a suggestion on the throttle pedal bracket, slotting the lower two holes in an arc would allow the gas pedal to be adjustable and wouldn't take a whole lot of work on your end.

Cool Stuff!!

randy, I stripped the harness down, cut it to length, repinned it and sheathed it in nylon sheathing to get rid of the corrogated stuff. Came out nice, so I drooped part of the harness from the backside of the engine to the driver's side firewall bulkhead. Then I ran the power wires up the driver's inner fender/out fender gap to the fuse box that I mounted behind the driver's headlight.

the little droop part went under the brake master cylinder, and since the bay was black and the sheathing was black, it's hard to see.

I built a bracket off of my DBW pedal. Sits really nice there and easy to get too

Digging up an old thread!

I'm looking for for a relay and socket that clips onto the GMPP Fuse box tabs that the mounts on page 2 of this thread are using.

Does anyone know what the tabs were used for originally?

Thanks,
Stan

Stan, just saw this and wanted to post it up for those that might still be looking for them.

https://www.summitracing.com/parts/sum-900485

Nice, I couldn’t find them so I made my own. This is the only pics I have handy....

PM sent Stan.