How about Earl's new vapor guard hose? I'm thinking about redoing my flex lines this winter.

https://www.holley.com/products/plum...arts/751066ERL

I flipped my rail and used PTFE line and fittings from plumbingmonkey.com from the tank to the rail. The line has since been secured to the firewall with a little slack to compensate for motor movement.

http://www.pro-touring.com/threads/1...ar-build/page7

Nice OEM look. I like it. Thanks!

Don

I have a local place that makes hydraulic hose and he is an expert brazer.... he could cut the end off of that rail and make any radius bend you need.

This may be hard to see... however it is a stock fuel rail being fed from the back driver side with -10AN fitting brazed on.... then the original feed is actually the return. There was also an additional crossover tube added..... to the quick glance it looks stock... but it does support 1400hp+. This is my other RX-7..... 88mm turbo LS9 1/2 mile shootout car. Does mid 190's with total lack of traction.

Happy with this
 

Got he Russell 90 fitting that's threaded very nice like how it ended up

Which 90* part# did you use ?? Thx

Russell 611223 Hose End

Thx!