Lateral-g Forums - Camaro LT5

Lateral-g Forums (https://www.lateral-g.net/forums/index.php)

- Project Updates (https://www.lateral-g.net/forums/forumdisplay.php?f=16)

- - Camaro LT5 (https://www.lateral-g.net/forums/showthread.php?t=57667)

Nice work on the exhaust. Are those made mufflers or bought? The welds make it look custom made.

Quote:

Originally Posted by WSSix (Post 702187)

Nice work on the exhaust. Are those made mufflers or bought? The welds make it look custom made.

Quote:

Originally Posted by Stielow (Post 701933)

Up next week is exhaust. Because Holley make a kit now hopefully it will go quick. But like everything on these car I wanted to modify the “off the shelf” system.

Holley did some one off mufflers to knock down the sound pressure.

https://lateral-g.net/forums/showpos...&postcount=268

Thanks for the update!
Have more questions for you, I know, I'm that annoying kid in class that asks all the questions :y0!:

What are the tabs/brackets circled below?

https://i.hmjimg.com/images/2020/04/...237D76F3D0.jpg

https://i.hmjimg.com/images/2020/04/...ACEBCB5ABB.jpg

We know you and most everybody makes those trunk notches in order to route the exhaust up over the rear, but in this one pic, it looks like there's a section taken out from the rear seat area. What was that for?

https://i.hmjimg.com/images/2020/04/...A2B704228D.jpg

As always, thanks for sharing and your time!

Quote:

Originally Posted by jmac (Post 702195)

The holes in the top photo are pass throughs for the diff vent, fuel tank vent Two Much Canisters. Also a pass through for wiring.

The tab in the middle photo is the pickup point for a brace brace that reinforces the pan hard rod. I’ve added this to my last 4 build to stiffen up the DSE bracket.

The last photo is the clearance hole we cut into the floor pan for exhaust clearance. We will fill patch it once the exhaust is done. It gave us a ton of extra room for the 3 inch pipe to go over the axle.

Sent from my iPhone using Tapatalk

Quote:

Originally Posted by 67_camaroRS (Post 702206)

Hey mark, what Master Cylinder, Brake Booster and proportioning system are you using on this car? Thanks

The Detroit Speed booster and master. Prop valve Willwood off memory.

Sent from my iPhone using Tapatalk

Quote:

Originally Posted by Stielow (Post 702208)

The Detroit Speed booster and master. Prop valve Willwood off memory.

Sent from my iPhone using Tapatalk

If you’re running ABS why are you using a prop valve? I’ve seen it on a few of your builds and with the C5 ABS I have for my car I know it controls bias. Is it just a back up fail safe you’re using it for?

Quote:

Originally Posted by CamaroAJ (Post 702214)

Yes I balance the system with ABS turned off then turn on the ABS. Yes it is an event of ABS system fault. Not likely but give me a piece of mind.

Sent from my iPhone using Tapatalk

Quote:

Originally Posted by Stielow (Post 702215)

Yes I balance the system with ABS turned off then turn on the ABS. Yes it is an event of ABS system fault. Not likely but give me a piece of mind.

Sent from my iPhone using Tapatalk

Good information. Does having the prop valve in it set to balance the car with the ABS off mess with the balance when the ABS is turned back on?

Anyone want to bet Mark's brain is running overtime with this quarantine thing ... off work, isolation,... coming up with his next great part, mod, build ,trend