|
nice goodluck.. do you have a thread? my set-up for the winter was a propane heater and a single car garage.:goofy:
|
Lookin good. Can't wait to see the results of your workspace.
|
You might want to consider going with the US Car Tool frame connectors and radiator support reinforcements. They are the guys that designed and created the original contour fit sub frame connectors.
|
I already have the XV pieces, but thanks for the tip..
|
|
http://inlinethumb15.webshots.com/41...600x600Q85.jpg
http://inlinethumb18.webshots.com/43...600x600Q85.jpg You can see the XV subframe connectors.. mix of welds and seam sealer.. http://inlinethumb33.webshots.com/43...600x600Q85.jpg http://inlinethumb55.webshots.com/42...600x600Q85.jpg |
|
Just an FYI, the contour fit frame connectors should be fully welded the entire length. At least that's what we recommend for the US Car Tool version.
|
Thanks for the continued pictures of your build. There are plenty of us here that wait anxiously for picture and updates. Keep on rollin' man!!
|
Looking good man. Keep us updated.
|
| All times are GMT -7. The time now is 01:53 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2026, vBulletin Solutions Inc.
Copyright Lateral-g.net