test
 

http://i1222.photobucket.com/albums/.../afterdip6.jpg

Thanks Phil,

Making progress
 

Completed work:
Steering Installed
Brake and clutch master cylinders installed and firewall smoothed around them
Trans tunnel completed
Fabricated new raised drive shaft tunnel and installed
Installed brake/clutch pedal and gas pedal
Radiator mounted to core support
Fenders and core support mounted to chassis

[IMG]http://i1222.photobucket.com/albums/...cture20270.jpg[/IMG]
http://i1222.photobucket.com/albums/...cture20265.jpg
http://i1222.photobucket.com/albums/...cture20260.jpg
http://i1222.photobucket.com/albums/...cture20259.jpg
http://i1222.photobucket.com/albums/...cture20255.jpg
http://i1222.photobucket.com/albums/...cture20254.jpg
http://i1222.photobucket.com/albums/...cture20253.jpg
http://i1222.photobucket.com/albums/...cture20252.jpg
http://i1222.photobucket.com/albums/...cture20249.jpg

Nice. What radiator is that?

Keep's getting better W/every post.:thumbsup: Scott M.

Great stuff. :thumbsup:

Making progress
 

Here are a couple of more shots.

[IMG]http://i1222.photobucket.com/albums/...cture20528.jpg[/IMG]

http://i1222.photobucket.com/albums/...cture20526.jpg

http://i1222.photobucket.com/albums/...cture20524.jpg

http://i1222.photobucket.com/albums/...cture20518.jpg

It is an Autorad Radiator

Always great stuff from you guys!

What do people use to get the uniformed smooth look when sanding to the bare metal?

It takes some skill on both the welding and metal finishing side. The quick answer is that you have to be able to weld the panels with minimal warping or distortion. Then knock the welds down with a grinder with out getting into the metal around it. We then do a lot of hammer and dolly work to make sure that all surfaces are even and uniform before final grinding. We step down the grit getting finer and finer and then finish it with a DA and then a red scuff pad by hand.