Looks good, what headers are you running with the DSE sub?

I used the hooker super comps but probally will change,just put a set of Kooks on one that I just finished for a friend and they were real nice.Using the 1.5" back motor mounts you have lots of room,also saw that Fesler had a new set of LS headers in stainless,hoping to see next week at Goodguys,Columbus.Also Ryan your car eally looks great.

not much for updates but finally getting back to work on body,just wanted to show these covers just got from Billet Specialties,very nice quality,should have alot more pics soon hoping to get bodywork complete over next couple monthshttp://i1192.photobucket.com/albums/...9/P1000671.jpghttp://i1192.photobucket.com/albums/...9/P1000670.jpg

Nice looking covers. They should keep the coils cool too.

Awesome job man, I believe you have got the Tremec TKO transmission, just wondering what hydraulic clutch master cylinder kit you are using? I realized also you are not using the hydraulic clutch master cylinder and wilwood master cylinder firewall bracket either.

Also are you using stock or a different clutch pedal to be utilized with hydraulic clutch master cylinder?

Could you please give me some input on the set up you are using and part numbers will be appreciated.

The reason why I am asking is because I have got TKO 5 speed as well mated to the LS6 engine. However, the rod connected to the hydraulic clutch master cylinder is way too long and a firewall mounting bracket was fabricated to mount the master cylinder as shown in the below photos, and I would really like to sort out this mess and have a clean install.

http://i218.photobucket.com/albums/c...Z28/photo4.jpg

http://i218.photobucket.com/albums/c...8/photo1-2.jpg

Your input is highly appreciated.

Finally after 5 months got back on car,picked up a set of NOS fenders that had been painted and bolted on the car,welded and smoothed core support,got doors and front clip gapped and in final prime,alot of cutting and welding to get good gaps with aftermarket doors and header panel.Hope to get on quarters and rear panel soon.http://i1192.photobucket.com/albums/...ps1331b6f2.jpghttp://i1192.photobucket.com/albums/...ps07823133.jpghttp://i1192.photobucket.com/albums/...ps36733070.jpghttp://i1192.photobucket.com/albums/...psebb796c8.jpghttp://i1192.photobucket.com/albums/...ps27fff4e3.jpghttp://i1192.photobucket.com/albums/...ps009f334f.jpg

Welded core support is looks awesome!! :thumbsup: :thumbsup: And those gaps are just crazy. :yes: :yes: I likey!!:hail: :hail:

thanks,welded up extra 45 holes

The build is coming pretty good, awesome job on the core support and the gaps

thanks,finally back to work and hope to paint by spring