Yeah, forget the quick release, How about that fancy new ring!

I washed them just for you.

What? That old thing? I've had that for like...60 days!

Check this out! Who can guess what we're making?

https://fbcdn-sphotos-b-a.akamaihd.n...57dbf1c2bd4ec8

https://fbcdn-sphotos-d-a.akamaihd.n...74cc96df378baa

https://scontent.xx.fbcdn.net/hphoto...73&oe=5574142F

I'll post a completed pic tomorrow.

Supercharger drive bracket. 1/2 the weight of alum one.

:y0!: :y0!:

Adapter to fit a round(ish) peg in a square(ish) hole?

No idea but I'm sure it's going to be rad!

no, no, no!!
Adapter to fit a square(ish) peg in a round(ish) hole? :underchair:

It looks like you are making a mess inside that machine. You guys should really stop and clean up a little bit. :mock:

Here's the final finished product. This is a custom mounting plate for one of our CDS Supercharger Gear Drives. We built it for Greg at Ultra-Carbon using a C/F "billet" that he supplied. The carbon fiber plate is half the weight of the aluminum piece that's sitting next to it.

I'll try to post a better photo later.

https://scontent-a.xx.fbcdn.net/hpho...61063382_o.jpg

For reference, it's going on one of these.

http://www.cachassisworks.com/site_i...sembled_ID.jpg

Here's a fancy photo I took with the CDS logo.

https://fbcdn-sphotos-h-a.akamaihd.n...2df7f523736c3e

WOW!! Had no idea you could machine carbon like that. Were there any special problems or techniques you had to use?


Jeff-

It's really tough on tooling but other than that nothing we hadn't dealt with in the past.