Awesome work. I'm anxious to see this one done. I have a soft spot for those Chevelles.

The rear bumper is underway. Chris sketched up some ideas that will really set off the rear of this car.

http://i563.photobucket.com/albums/s...ustopening.jpg

Not too much of the original metal left here!
http://i563.photobucket.com/albums/s...ture220539.jpg

The bumper has been narrowed and tucked tight to the body. Now working on fabbing a new sheet metal center section for the bumper.
http://i563.photobucket.com/albums/s...ture220560.jpg

killer back end that will give it another look,:thumbsup: Are you changing the rocker to flow with the rear?I have been keeping up with the build more pic.

More awesome work by the RS team!

quick question when you guy are doing a car that need all new sheetmetal do you all use the weatherstripping to check correct door to 1/4 and trunk to 1/4 fit?

Norm, we will generally either buy 2 sets of weatherstrip for the car (one for mock up and the other for final assembly use) or we will figure out the thickness of what the weatherstrip is and then tape rubber or shims in place to act as the weatherstrip.

Some further progress on the rear bumper. It is just about completed at this point. We need to go back and fine tune the gaps and final mount the bumper and lower valance. Then begin on the center exhaust tip.

http://i563.photobucket.com/albums/s...ture220636.jpg

http://i563.photobucket.com/albums/s...ture220634.jpg

Splitters added to the recessed area

http://i563.photobucket.com/albums/s...ture220663.jpg

http://i563.photobucket.com/albums/s...ture220666.jpg

2 things:
that rear end treatment is awesome.

sweet! another shot of the secret car!

Not Bad.:thumbsup:

Wow. Looks great guys!