Complete all new panel, everything was garbage and I use ppg dp90 inside the panels

Someone got a quadralink sway bar and can take a measurement for me?
I need to know the width of the bar, I have some news later.
Thanks

https://i.postimg.cc/63Bc0DDh/20200522-081108.jpg

34.25”

Mine is 34.0" outside to outside. Flanges are 3/8" thick.

thanks guys
I think it will clear my lower shock mount brackets. I will measure it and if it clear I will relocate my previous fuel lines.

I change my mind a little and decide to go for a more pro touring style but still on leafs. I hope that the leaf will give me a little bit of race feeling.

More to come soon.

Thanks for interest, it give me a lot of motivation

I plan to use speedtech road assault front kit.
Any suggestion for the rear sway bar size?
3/4, 1 or 1 1/8 inch size.

From my measurements I got 34-35'' between my shock mount plates.
Maybe the plate will need a little trim to clear but I think it will fit

I ordered 1'' rear sway bar and the hooker t56 tunnel hump, need to install it and i'm ready to prime this. That was a lot of job.

I love bare metal

https://i.postimg.cc/sDn6G9fv/20200528_181136.jpg
https://i.postimg.cc/y8kfmgWn/20200528_180913.jpg
https://i.postimg.cc/wjZw0qmz/20200528_180845.jpg

Amazing work....:headspin::headspin:

It does look good bare. Good job!

The progress pictures look fantastic. What rear suspension are you planning to use as most 2nd Gen don’t use sway bars.


Sent from my iPhone using Tapatalk