|
More progress
Found a good place for the trunk release.
http://i370.photobucket.com/albums/o...9445300025.jpg Got all the exhaust welded up and smoothed out. I will never do that again. http://i370.photobucket.com/albums/o...4944850007.jpg Then started on the gas tank. Made a full size mock up of the tank to make sure everything fits. I have a stainless tank made with the vaporworx internals. Carl C was helpful to give me some parameters to work with. http://i370.photobucket.com/albums/o...6344990007.jpg http://i370.photobucket.com/albums/o...6244980006.jpg Rodger at Ironworks got my tank mounts and tie downs laser cut, WAY easier than hand cutting. Can't thank him enough for these. http://i370.photobucket.com/albums/o...8145170012.jpg http://i370.photobucket.com/albums/o...8245180013.jpg |
Got the tie downs tacked in place. I'm going to start on the rear pan and mock up some exhaust tips next.
http://i370.photobucket.com/albums/o...8545210016.jpg http://i370.photobucket.com/albums/o...8745230018.jpg http://i370.photobucket.com/albums/o...8645220017.jpg Made some close outs that will tie into the rear pan. http://i370.photobucket.com/albums/o...8845240019.jpg http://i370.photobucket.com/albums/o...4744830005.jpg |
Very nice work,This is going to cool as# car.:thumbsup:
|
Incredible detail and craftsmanship! Great job!
|
Absolutely stunning:wow::thumbsup:
|
Amazing work. Very nice.:yes:
|
I can kinda see it in the pictures, but what kind of wheel barrow did you use to make the outside curve of the fuel tank again?
Rodger |
Amazing work Jason! Attention to detail is stellar!
|
Amazing work :hail:
|
| All times are GMT -7. The time now is 04:01 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
Copyright Lateral-g.net