Excellent progress 'X' . :thumbsup:

Nice job!! I'd say weld the brackets as well.

for Ratman67 this is where i measured for ya... 115".

ECU and DBW
 

Today I made up a floor mount for the DBW and then made a bracket for the ECU. I have to wait to get my gauges in so I can make sure the ECU location works. If its good clearance wise I am thinking of just welding it to the cowl
Not a lot of room with the AC ducts right there....

Took the day off.. got a good amount done... started with wiring made a lot of progress then decided to make some changes that require weatherpack connectors I dont have... (if anyone now a good source let me know)
Got the clutch master hooked up. I took a slightly different approach. I shortened the rod on both sides, then drilled into the fat end and ran a tap into it. Then ran a Die over the small end. this gives me about .5 to 1 inch adjustment.
started on my gauge panel.. too some 3" exhaust pipe slash cut them @45 degrees this is a rough in it will be much better fitted into the dash before its done. hoping for a factory look when its done.

Guages in
 

working my way through Dash Moc up.

Lots or wiring on the bench
 

completed my wiring on the bench.. now time to MOC it into the car. Fist step Batt.... (BTW Optima no stickers with a new Battery? ) the cutoff is removable goes through the lower bolt hole of the bumper for track days.

The gauge cluster looks Great! The battery install looks good too.

Bling
 

Brown truck delivered some Bling this week :G-Dub: