Total Control Products suspension.

We do! You can get one through Rusty. For more details check out this link: http://www.totalcontrolproducts.com/rack.html and be sure to check out the 'Downloads' section too.

The owner wanted the car assembled so the stainless exhaust could be designed to fit around the Total Control Products rear suspension and subframe connectors in case anything had to be modified before paint.

On the way to the exhaust shop on a dreary rainy day here in Florida

http://img.photobucket.com/albums/v3...ps2728b4c4.jpg

Looking good!

Sorry I have forgotten to update.

Stainless exhaust

http://img.photobucket.com/albums/v3...psmsas0ztx.jpg

http://img.photobucket.com/albums/v3...ps1trszmtb.jpg

http://img.photobucket.com/albums/v3...ps2nagxoyj.jpg

http://img.photobucket.com/albums/v3...psveus1cgv.jpg

Brian cut the holes for the speaker and light in the door and lined up the trim

http://img.photobucket.com/albums/v3...pscq3mfwyw.jpg

http://img.photobucket.com/albums/v3...pssk0wesff.jpg

We removed the engine and transmission

http://img.photobucket.com/albums/v3...psu1phuexg.jpg

http://img.photobucket.com/albums/v3...ps4mgo0cfw.jpg

Lookin' good, Rusty!

A few new problems. Brian is test fitting the windshield molding and of course they don't fit.

http://img.photobucket.com/albums/v3...pszzzlhqvo.jpg

The next problem is the brackets for the fold down rear seat are welded in the wrong location on the wheelhouse

http://img.photobucket.com/albums/v3...psagjmojkq.jpg

This is how it should be mounted

http://img.photobucket.com/albums/v3...pscxao5vfq.jpg

It is mounted to high

http://img.photobucket.com/albums/v3...psgwma6luo.jpg

This is the opposite side

http://img.photobucket.com/albums/v3...psajtajlzc.jpg

Brian had to cut and modify the windshield pillar to get the molding to fit

http://img.photobucket.com/albums/v3...ps2from18w.jpg

He finished welding

http://img.photobucket.com/albums/v3...pswqf0edst.jpg

Welds ground

http://img.photobucket.com/albums/v3...psplslcbvt.jpg

Brushed a little epoxy to keep if from getting any surface rust

http://img.photobucket.com/albums/v3...pst0poeuvi.jpg

After a lot of test fitting the seat brackets are welded in place

http://img.photobucket.com/albums/v3...psfkevnkpv.jpg

The fold down rear seat must have been in and out of there at least 6 times but it now fits and goes down without hitting the interior trim panels

http://img.photobucket.com/albums/v3...psebz9b7qi.jpg

The suspension was removed so the body can go on the rotisserie to finish the undercarriage.

http://img.photobucket.com/albums/v3...ps7iybqt16.jpg

http://img.photobucket.com/albums/v3...psno6p3p3a.jpg

Brian applying seam sealer under the cowl.

http://img.photobucket.com/albums/v3...psnolx3qvm.jpg