Thanks!

I've got a few updates to share...

Almost done with the air intake tube. I just need to weld on the MAF bung and then have it powder coated. I also finished making all the AC and heater hoses.

http://i263.photobucket.com/albums/i...psltdbqnol.jpg

I finished making the oil cooler and accusump lines (the zip ties are temporary until I get some actual hose separators).

http://i263.photobucket.com/albums/i...psmszdt57d.jpg

The exhaust is done.

http://i263.photobucket.com/albums/i...psv7kulgpd.jpg

And I figured out my radiator hoses. The upper hose is a Gates 22147 with 1" trimmed of the radiator end. The lower hose is a Gates 22437 with 1" trimmed off the radiator end and about 4.5" trimmed off the water pump end.

http://i263.photobucket.com/albums/i...psrmse1mmi.jpg

I'm sure there's a bunch of things left to do that I can't think of at the moment, but the only big things now are the engine harness, AC harness, put the interior back together, and a dyno tune once it's up and running.

Air intake boot
 

Looking good Herb, is the boot for the air intake coming off the throttle body a 90 degree piece, what diameter, and who makes it. Thanks

It looks good Herb. Nice job.

Thanks! Yes it's a 90*, 4" diameter elbow from Spectre Performance through Summit.

Thanks!

Beautiful work as usual Herb...can't wait to hear it run!

Thanks Matt. :cheers:

Hopefully before the end of the month I can fire it up!

Following some wiring gremlins, I finally got the LS3 up and running! :excited:

SAWEEEET! That sounds nice.

Thanks!