Nice. That's great color.

awesome update Steve!

I am really starting to think this car will be magazine material when finished! lol:D

That firewall fill plate looks killer! Keep up the good work

very nice firewall, can't wait to see more

Looks good! love that color too :thumbsup:

Firewall is almost ready to be bonded and then welded. The holes are cut for the master cylinder and steering column. Not that I have my ATS clutch master and bracket we can cut that hole as well.

That's it.. only three holes in my entire firewall.. The new trans tunnel has been tacked in place and it is raised almost 2 inches at the firewall for T56 clearance. The pre-fabbed pieces from 21st Century made it a LOT easier. Next week it will all get bonded with the super epoxy and welded. Then the studs for my fly by wire throttle peddle will be welded on.

Last pic is where I have decided to mount my GPS antenna for the track data logging computer. It's magnetic so if I want I can open the trunk.. unstick it from the outside and stick it to the inside of the trunk.

Man thats going to look sweet!!! :thumbsup: Keep us udated, Steve.....

Can you tell me more about the system you choose

Looking good Steve :thumbsup:

http://www.g2extreme.com/

:yes:

Looking slick!

Here is a challenge for you.

Is it possible to sheetmetal trim the inner upper horizontal lip of the fender so that it is smooth and slick from the exterior lip going into the engine bay? I had thought about doing this on my car because that is an unattractive area that I don't see anybody doing anything about.