![]() |
1 Attachment(s)
If my Mast oil pan ever shows up, I might actually be able to take some pics of this thing sitting IN the car!:rolleyes::rolleyes:
|
Quote:
|
Quote:
|
What is the length of your rearend?
|
Quote:
GM 12-bolt 30-spline Custom Alloy Axle Shafts - 30-spline axles - Torino Flange / Press on Bearings - Axle flange OD 5.90" or less - Axle shaft pilot OD 2.778" or less -1/2"-20 x 3.00" Studs, Press-in - GM 5 on 4 3/4" bolt circle - Add access hole to axle flange - 1/2" Pinion Offset - "F" Measurement; 25.375" - "G" Measurement; 24.375" -Total axle width 54.750"axle flange to axle flange That's pretty much what your rear end will be if you order their standard config for use with mini tubs, Quadralink, etc. Obviously, they'll make it any dimension you want if you need something different. I toyed with the idea of squeezing 335's back there but I'm glad I didn't, they wouldn't have fit. Since I wasn't repainting the car yet, I didn't want to roll the rear fender lip and risk excessive paint damage and that would be a requirement no doubt for 335's. The way it is now, I have aprox 1" clearance on the outside and probably about 1.25" on the inside. I haven't measured it for certain but there's plenty of room for travel and lateral tire movement. Hope that helps. If you need anything more specific, let me know and I'll get it for you! |
Thank you for the information and that is a beautiful
blue |
Very nice! Great list of parts!
|
Quote:
|
Quote:
Your car is is just how I'd like my 68, when I take it apart and build it again :confused18: |
Loving your build - pretty color too
|
| All times are GMT -7. The time now is 11:18 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2026, vBulletin Solutions Inc.
Copyright Lateral-g.net