Thank you for looking, Marty. I did receive the fittings and will be moving on to completing the A/C setup once I finish the main wiring.

I have the panel made up and am in the process of mocking up the layout of the electronics and the wiring. Once I get it how I like it, I'll take it apart and fine tune the panel and paint it.

Just a tiny update…

BISKWIK got some new shoes and improved stance!

Here are the Before and After shots.

Matt, that looks soooo much better. Well done sir.

Thank you, Scott!

Hopefully it will be moving under its own power soon.

Not much of an update. We went on vacation early February and I got pretty sick upon return to the tune of 103 fevers with meds and a total weight loss of 19 lbs in a week and a half. I was in bed for three days and wasn’t able to eat. We are guessing it was a strain of some type of Flurona. 🤷🏻*♂️ A month later and I’m up four lbs and my stamina definitely isn’t what it used to be. I’ll get back to where I was, mainly because I’m stubborn.

I did get a new radiator/ fan setup for BISKWIK though. I’ll be working on getting that mocked up with the MSD Solid State relay. More pics to come!!!

I did manage to get the fans mounted and the setup temporarily in place. I wanted to make sure there was plenty of clearance with the steering box and the accessory drive. All looks good so far! I just have to massage a couple holes on the fan shroud to get them to line up properly.

I was also able to make some progress on making panels to fill in the holes between the back seat and the trunk. I did not seal it off completely, but it is a vast improvement over what it was. The wheel wells have a healthy layer of undercoating in them, so I did not add any material to the interior.

Once I completed that task, I employed the help of my Mini-Me and installed the seatbelts in the back. Once we got those bolted in, the backseat was put back in place. It’s a little dirty and will be cleaned, but it’s starting to look like a car inside again!!!!!

The seat cushion got tweaked a little over the jump area while putting it back in. I will be pulling it back out to address that and make it uniform again.

Finishing the wiring and fuel system will be next…. Hopefully.

Stay tuned!!🤙🏼

The smiles on those kids faces says it all. Makes everything well worth it.