Randy,

Good to meet you today. I remembered seeing this thread a while ago and did not put 2 and 2 together until I got home. I can't wait to see it when it is done. Any chance of it being at SEMA this year?

Jeff

sema
 

[QUOTE=Van B]Randy,

Good to meet you today. I remembered seeing this thread a while ago and did not put 2 and 2 together until I got home. I can't wait to see it when it is done. Any chance of it being at SEMA this year?
Jeff,
It was also nice to meet you. Not shure if the camaro will be done. We (tom nelson and I)backed out of sema this year since some components are only in the drawing stage and need to be built. It will be a few months yet. If it gets done by sema we will try for a long shot.

Thanks
Randy

What size rim does it take to fill out that 345-18 BFG Drag Radial? What offset? Did bent custom do the fuel system?

rims
 

The rims are 12 inches wide 2.5 outer and 9.5 inner and yes bent custom did all the stainless lines. I will be at nelsons on the 29th tom and I are going to sema on the 30-31st. That 92 you have looks good

intake
 

Here is a pic of my intake wich was built by www.nelsonracingengines.com

Thanks for the kind words, still a country mile away from where your car is. I work for one of the major manufacturers local to Nelson Racing which I'll leave nameless. I have to work SEMA will the car be there? Will it be in a booth or outside?

sema
 

Sorry the car will not be done for sema. The car is at toms shop so you are close to it. If you see tom at sema I will be with him.
Randy

Is that the notorious $8000 intake?

Everything looks amazing.
Thanks for the update.
Kory

intake
 

Yes that is the nelson billet intake.