Wheel Simulator
 

Here is a wheel simulator that we machined up to use in on our shop for wheel offsets & for when we are setting up rear suspensions.. I have been asked if I can make one to sell.. In order to set up a machine for me to run these components for a assembled unit I would have to have more request or intrest.. It has a total of 18 machined components.. It is not the easiest tool to set up on a tire but works great!! It can be used for 15 to 20 inch wheels & up to 14 inch wide rims.. Bolt circles for 5x4.5 to 5x5.. I dont have a cost on what I would sell these for but the more assemble units I have to sell the lower the cost to produce :unibrow: Let me know what you guys think! Thank you!

http://i1015.photobucket.com/albums/...n/P1010018.jpg

http://i1015.photobucket.com/albums/...n/P1010019.jpg

http://i1015.photobucket.com/albums/...n/P1010020.jpg

Okay i am interested. Currently i have the mount mate but wouldn't mind having on of these.

its surely a piece of art!, I'd like one but it looks very expensive. please PM me the price when you have it.
Shipping would be to Italy

i would be interested if the price is not crazy but that is a verry nice tool

Interested

Interested also.

I'm interested. Would you be able to use this to figure out tire size also without having a tire to mount it to?

We did not design this tool for tire size.. We use the attached tool for that.. It mounts & opens to measure how wide of a tire can be used..

http://i1015.photobucket.com/albums/...n/P5240131.jpg

tools
 

Gonzo

Damn nice tools you came up with....

tom

Thank you!

Very nice looking tool there buddy.. Puts the wheelrite to shame.

I cut up a similar working tool as the wheerite using wires for the tire. I was too lazy to turn on the mill to make a nice one like yours. JR

http://img.photobucket.com/albums/v3...a/17incher.jpg

You think you guys made a nice one? Check out my state of the art design I made about 7 years ago :lol:

http://img99.imageshack.us/img99/255...ires010vu9.jpg

Nice! Yours gets the job done :thumbsup:

Nice tools. Are you going to make them both? Will you sell as a set or seperately if you get enough interest?

I can make either tool.. & yes I would sell them seperately.. We are looking @ getting getting cost out of the wheel simulator.. When we first made the tool we looked @ offering it to sell @ 800.00..

Gonzo is this a go yet??

Working on design to get some cost out of it Mario.. Should have a confirmed selling price early next week :_paranoid

nice job looks very high quality. great craftsmanship.:thumbsup:

Thank you!

I don't suppose you ended up making an extra one of these which you would be interested in renting for a week or so, did you? :)