Kevin's Mustang
 

Kevin came to Big Head Motorsports for custom stainless steel header's and bullhorn exhaust. It's a SBF 438" Edelbrock SC1 Glidden head's, F3 Pro Charger and putting out an estimated 2100hp. Should be in the low seven second zone.

http://i599.photobucket.com/albums/t...ustang2037.jpg

http://i599.photobucket.com/albums/t...ustang2070.jpg

http://i599.photobucket.com/albums/t...ustang2073.jpg

http://i599.photobucket.com/albums/t...ustang2086.jpg

http://i599.photobucket.com/albums/t...Exhaust021.jpg

Yeah - That'll work!


Nice welding and workmanship as usual!

Yeah that's a serious hp per cube number. :unibrow:

:thumbsup:

Are you purging when you're welding up the tube to the flange or is it not necessary then??

Wow Sweet!

Greg, it's not necessary. With the primary tube being 16ga you won't have any problem burning through. Just make sure you use .045" filler rod. Anytime I use 18ga material I definitely back purge. Also, if I use a weld on collector I back purge because there is so much heat being placed in one area.

Yeah that's some bitchin work. Nice job once again.

Nice work, Alex.

Thanks man!

Thanks again!

That's beautiful! Nice car!

Hey Alex, do you have any better pics of that badass CDS Supercharger drive setup?

Sorry Carl. I don't have anymore pics.

So whatever happened to this project ??

Sorry Greg. It's been a while since I've been on here. I've been really busy with the business and family. Kevin's car is running, but hasn't really made a full clean pass. I know he put it into the wall, no major damage. He should be out there soon making test hit. Thanks

Good to hear from you! A busy business is a good thing so we won't fault you for that!!