FS Vintage Air, Ring Brothers, Quicktime
 

I have a few items for sale, they are all brand new and have never been installed or mocked up.

Quicktime LS Bell Housing Part #RM-8020 Retail $600.00, Sell for $500 SOLD

Quicktime Bell Housing Spacer. This is a custom billet spacer made by D&D Performance. This spacer is needed if you are going to run a ZR1 clutch with a T-56 Transmission and an LS engine. This is same spacer Mark Stielow uses on his builds. Retails for $250.00, Sell for $200 SOLD

Ring Brothers GM two piece billet door handles, black anodized, SOLD

Vintage Air Streamline Gen IV vertical control panel, black, Part #491226-RVA, Retail $210.00, Sell for $160.00 SOLD

Ring Brothers billet hood pin kit. This is black anodized. Here is the info. http://ringbrothers.com/exterior-acc...n-kit-736.html. These are brand new never installed or removed from packaging. Retail for $200, Sell for $160.00

Buyer pays actual shipping cost, I am located in Tracy, California 95376.

Vintage air
 

Pm sent on vintage air

PM sent on billet door handles

PM replied

PM replied

Billet Handles....Those baby's are mine!.. :thankyou:

Vintage Air
 

PayPal sent for vintage air

Vintage air
 

Received the vintage air controller today.
Thanks Greg!!!!

bell
 

pm sent on the bell.

I have not received a message from you and your mailbox is full.

Sent you a pm on the bellhousing no reply?

bell?
 

I haven't received a reply.. I sent another response. did you receive that?

PM's have been replied to, there is a sale pending on the bell housing and spacer.

I have added Ring Brothers hood pin kit to my sale list. See post #1 for the info and price,

I'll take the hood pins. PM payment info. Thanks.

PM Sent