Mann Hummel advice sought
 

I have a 416 LS3 in my Camaro. Dart block and heads, Holley throttle body injection - 600hp. Currently the engine vents into a firewall mounted catch can (see catch can beside a/c firewall lines), with vent hoses plumbed off the back of the thick spacers which sit between the engine block and valve covers on both banks, and thus both sides of the engine feed into the vented catch can - venting to the atmosphere.

I'd like to go to a Mann Hummel closed vent system, draining back into the sump and am seeking plumbing advice.

Is the plumbing as simple as taking the existing hoses from each bank and plumbing them into the Mann Hummel Pro Vent 200 can; plus routing the Mann Hummel drain vent into the LS3 sump?

The MH part, like the Provent 200, is meant to be used in-line with a PCV valve. Basically...

Drivers valve cover -- PCV--MH-- throttle body vacuum source.

Vacuum is needed for the drainback valve to actuate.

That's great advice - thank you very much. I think I could plumb a PCV into my current drivers side hose take off, which goes from the spacer that sits between the engine block and the 'valve cover'; then feeds to the current catch can.

Do you think this PCV valve in line in the current drivers side hose would be ok?

https://www.amazon.com/Beck-Arnley-0.../dp/B000CB0X9K

Then out of the MH 200 and into a spare vacuum port on the 4150 Holley throttle body, plus a drain to the sump.

Image - drivers side take off from valve cover spacer

The pickup point being low like that will likely pull in excessive oil. The PCV system will be much more effective if the pickup point is higher up on the cover.

I'm not familiar with that PCV. I use a stock 4th gen with good results but the camshaft is relatively mild. M/E Wagner has an adjustable valve that may work well.

I like how you did the steam tube! Very clean looking under the hood!

Thanks. We were working on an OEM look under the hood.

Thanks for the advice Carl. I like the idea of the adjustable M/E Wagner.

Killer looking engine bay! Love it!

Thanks !

Check this out. It may help answer a lot of your questions about the oil pickup point vs. oil consumption. It's quite enlightening.

http://mewagner.com/?p=1221

That air cleaner is over the top cool!

Just here to say, AWESOME ENGINE BAY !!!!!

Thank you

Thanks, I really like it too.

Just looking at the Godfathers last post and didn't see mention of a PCV in the system?

I'm still working on location of the PCV. A traditional PCV in the valve cover is problematic because the (fake) valve covers are closed and non functioning - they sit on top of this spacer on the cylinder heads that mounts the coils, and do not offer direct access to engine breathing.