TMI one piece headliner
 

I am rebuilding my 68 Camaro and have a Detroit Speed 4-point rollbar. I am looking at the one piece TMI headliner and was wondering if it can be installed over the rollbar.
Thanks

I believe it can be since it's installed from the side. I would recommend checking with Waylon from TMI, [email protected]. If it's been done he could tell you.

install instructions: https://static.summitracing.com/glob...p-12002229.pdf

Most definitely. I did mine, and my roof had a layer of dynamat on it. Like stated earlier, goes in through the side then spin or rotate into place.

Thanks for the info, do you have any pictures to share?

I will take some tomorrow.

Did these pictures ever get posted anywhere? I'd like to see them too.

I haven't seen anything yet.

I apologize, I haven't been able to go to the Upholestry shop. With this COVID epidemic and me working in the hospital system I have been busy. I will try to get over there this Wednesday.
Thanks
Jonathan

Roll cage
 

Hope this helps

Thanks for the pictures Jonathan, looks great. Did you install it from the side?

Thanks! Yes sir I sure did. Went in through passenger side then up and over.

Very nice, is that a kit rollbar or custom? Any more pictures of the rollbar?

Roll bar
 

Here you go

Is that a TMI rear seat? Entire setup Looks good!

Thank you sir. It is actually a custom made seat based off of a fesler rear seat frame. All custom built foam with Ferrari leather. Hard to see it, but has perforated leather inserts