Bullit Mirrors / Electric?
 

How do you make bullet mirror electric?

I've thought about building a set of electric bullets, too. My idea was to pull the motors from a 80's model GM and fit them into the bullet shell. Unfortunately, I've not even gone so far as mock-up. So all of the following is my unproven idea.

For mounting provisions, there are a lot of good epoxys out there that can be drilled and tapped. A simple damn can be made from masking tape to create the mounting ears and then, with a little patience, the mounts can be ground flat, drilled and tapped. It seems fairly easy but it all would depend on finding a motor that would fit into the bullets deep enough to allow the mirrors to mount at their stock depth.

I'd be interested in hearing about some other ideas and successes.

well its a start. I know there were some guys doing it before

All I can say is stay tuned. I have been working on this for a while know.:unibrow:

ok shannon, I got a few of your products now, two more won't hert. :thumbsup:

:cheers: Keep us informed!!