rear end width for 1st gen camaro
 

i think I hurt my 12 bolt last night and I've been looking this morning for a 12 bolt.

I've seen 54 " from backing plate to back plate.

Just wondering what i should be looking for.

60" axle flange to axle flange. GM rears have 2,75 and 2.81 of axle face to housing end offset, Fords are 2.36 and 2.50 so using housing end width is dangerous. So use axle flange to axle flange

frank

long shot, do you still have the one for the g-bar setup??

I have them at Moser. I expect shipping rates to drop this week with the .50 fuel drop.

send me a price when you get a chance.. It looks like the pinion is gone. not sure what has happened. maybe pinion angle still is not right?:mad:

Call me. I do not remeber all the specs for your car

I am doing the SEMA Boogie on Larry's MotiV8tr all day till 10 PM eastern if you want to call

four zero seven 832 1752

frank

i've got to free up some money, but I'm going to go with the one you recommend.

Give me a few weeks and I'll be in touch.

Mike