Ring Brothers CNC'd clutch master reservoir
 

Here are some pics of the new CNC'd clutch master reservoir from Ring Brothers. It's made to be a direct replacement to the standard GM plastic unit. It's a two piece design, the reservoir can be slid up and down inside the mounting bracket. It uses the GM lid seal/diaphragm, so the fitment and function is same as stock. It will come with a barb fitting for use with the stock rubber line, but the bottom of the reservoir is tapped 1/8NPT so AN adapter and line can be used instead if you wanted to go that route. The finish is annodized titanium and looks trick.


https://lateral-g.net/temp/RB_clres_01.jpg

https://lateral-g.net/temp/RB_clres_02.jpg

https://lateral-g.net/temp/RB_clres_03.jpg

Too fricken cool

Mike was going to give me one at SEMA but he couldn't find it in the trunk of RAZOR.. I guess I know what Jim did with it! :lol:

Killer part that I'm dying to try... all of their stuff is done so well.

yep, Jim snagged it for Scott to get some pics up on the site.............:D It is a very cool unit, like all the Ring Bros items are.

Jody

They have 100 in stock right now, they're just waiting on the 1/8NPT barb fitting and the diaphragm.

I have an idea on what the price might be, but I don't want to post it in case I'm wrong. I also talked to Jim and Mike about doing a group purchase on the site and they were interested. I'll get the official pricing tomorrow as well as any info on a possible group pricing.



This has been a project that Jim, Mike and I have been working on for a few months. I leaned on them for this product this past summer as well as supplying them with a stock plastic unit for basic form factor measurements and did the trial fitting of the unfinished prototype last month.

:cheers:

Very nice piece!! :thumbsup:

:cheering: first class.
rick k:cheers:

Ill buy one!!!!!! like tomorow

That looks beautiful. They make the best stuff.

me wants!!!