Intro Twisted Vistas, 20x8, Nitto Invos
 

I am new to the site, but figured I would give it a shot. I can give tons of feedback ratings from other forums, as well as over 100 positive feedback on ebay. I am selling the wheels because I have decided to go a different route all together with my build. After speaking with Rushforth, I think that's the way I want to go as they will fit the theme better. The wheels are in pristine condition but they have been mounted on the tires, therefore I cannot consider them "brand new". They have NEVER been driven on, never seen weather, never been "used". It's a set of 20x8 inch twisted vistas, one of my favorite wheels that Intro makes. The backspacing on all four wheels is 4 3/4 inches.

The tires are the new nitto invo tires, fronts have a set of 245/35/20's and the rears, 255/35/20. I understand that some might want a wider set for the back, but I will still attempt to sell them here.

I am asking $2600 for the wheels and tires, or $2000 without. Shipping will be covered half and half. I pay half, you pay half:willy: . If you have any questions at all please email/pm me I will answer them promptly. :woot:

http://i16.photobucket.com/albums/b4...s/SL370658.jpg
http://i16.photobucket.com/albums/b4...s/SL370660.jpg
http://i16.photobucket.com/albums/b4...s/DSC00767.jpg

Please note: I am willing to take any reasonable offers at this point in time!

KENNY--THAT IS A 5 ON 4 3/4 PATTERN??? BEAUTIIFUL WHEEL!! NEED MORE PICS WHEN U GET NEW WHEELS !! WE LIKE ALL PROJECTS WITH A "HANDS ON" OWNER!!:unibrow: :unibrow: JIM

SOAB Kenny! Don't those frames hang down a lot further than that? What did you cut the floor out of it too? That's a killer ride right there! Oh, and best of luck with the sale!! :thumbsup:

They are 5x4.75, with 4.75" of backspace. I am uncertain to what the backspace setup on a G-machine might be, but I know most bolt patterns would match up. Seems like the other set of Intros that sold were the same setup!:thumbsup: I have big plans for the blazer build from here on out, just need to sell these wheels to free up a little money. The frame is completely rebuilt from the firewall back with 2x3" tubing. The floor is stock for the most part, except for the tubs in the back.:lol:

I am more than willing to split, as I have a buyer lined up for just the wheels over on another forum. I wanted to see if I could sell them as a unit instead of getting them dismounted but obviously no interest:(

For both, right now, I am willing to take 2300. I need to get saving to purchase my Rushforths and I need to spend some money in different parts of the build!:yes:

Is it the price? wrong backspacing? Just a little input. I will stop bumping once I know what the problem is :)

Those sizes don't work well on first gen Camaros which is the most popular car on this site. Most guys want a 9.5 or 10 inch wheel for the rear, bigger if it is minitubbed. 20's are not very popular either and might be tough on the front.

Just my two cents worth,

Don

Hey no big deal. Figured somebody might want to step out of the norm. The 8 inch wide wheel I understand the lower level of interest, but, I still wanted to try.

These are one of the best looking wheels on the market today and are the correct size for my car. But I just picked up a new rolling chasie, 6.0l 4l80E combo this week and money is now way to tight. If it were a few months later I would be all over it.

Good luck.
Matt