LSX Motor Mounts in 69 camaro help!
 

What are the best motor mounts for putting a LSX engine and 6speed into a 69 camaro? I want to avoid having to cut the tunnel on the car, so I need mounts that will put the engine forward slightly or lower in the frame...

On the left side you will notice our sponsors, Give Kurt at AutoKraft a call he has great products and supreme servive.:thumbsup:

Travis

Some good comparison photos in here:

http://www.camaros.net/forums/showthread.php?t=172204

I think ATS mounts place it the lowest but headers that don't need hammering to fit may be hard to find.

Don

From what I've heard, the S&P mounts along with Stainless Works headers work perfect for stock steering on first gen Camaros.

We have them in stock and i have never run into any headers that are an issue...........YET. we can set you up with everything you need
T56 X members will be ready to ship next week
firewall brackets are in stock.
stainlessworks headers is who make our subframe headers so we have an in there also

Just curious what headers you have used with ATS mounts and stock steering. The only ones I have seen that worked were ATS headers. The SW headers did not fit. I remember Tyler telling me that SW's would not make the needed mods but that was a few years ago.

Don

I actually did an update that showed the PerTronix (Doug's) mounting plates that allow two mounting positions: one simlar to the Hooker plates and one similar to the Edelbrock pieces:http://firstgens.com/phpbb/viewtopic.php?f=16&t=317

By the way, the ATS plates seem to locate the engine in exactly the same place as the Moroso/DSE/Autocraft/S&P plates.

ok Don... ya got me. we have used the SW headers with the ATS mounts on oursub frame. i was under the impression that our (ATS) mounts being that we did not design them, are in Exactly the same location as all the others??

here is a pic for referance they look the same as DSE, and a couple of the others.

Back when I bought my headers, Stainless Works later revised thier stock steering header to this design. These should work with the ATS plates.

http://www.ls1tech.com/forums/attach...cs-drvrhdr.jpg

I wasn't trying to catch you. I was just trying to find an answer to one of the most commonly asked questions about LSx swaps. If you could say what headers work with the ATS plates that would help out a lot of people asking the same question. If the SW headers now work that would be great.

Don