Ford 9" and OCD?
 

I just purchased an Art Morrison chassis with the C6 Corvette front suspension and 4 bar rear. The Corvette hub uses a metric bolt pattern and stud while Art Morrison only offers a Strange axle with an "english" pattern and stud.

Thanks to a little OCD this is going to drive me nuts.

Options:

Have english studs made for the Corvette hub?

Use a different axle supplier that will accommodate a metric pattern and stud?

What is everyone else doing. Anybody have any good options or suppliers?

Thanks,

Nick

pattern is same. 5 on 4.75

you can press out and press in new 1/2 inch studs, moroso and arp make some. you may need to drill for proper press fit but its easy.