Brand New Baer Extreme+ 6S brake system (C5/C6, Ford 9")
 

Guys,

I have had this for awhile, planned to use it on my Morrison front clip... but now everything is for sale :)

This will fit c5, c6, DSE, or ATS front spindles!

Front is a Baer Extreme+ 6S, this is a monoblock 6 piston caliper mounted to a 14" slot, drill, zinc plated 2pc rotor. The calipers are the rare hard anodized finish (no longer offered by Baer). The center hats were also done in a hard anodized natural finish. Front system would normally list for $2995.00

Rear is a Baer Extreme+ 6S, same hard anodized finish with custom hard anodized hats. The rear is for an early Ford Big Bearing (not Torino) and is NON park brake. If someone has a different rear flange (Torino etc) I can probably have the brackets swapped.

If someone was dead set on park brake I can also work something out, though the hats would have to change to a standard black finish and would cost extra. The rear would normally list for $2995.00

I have pics, just not sure how to post them on here.. so if someone wants them please e-mail me direct at [email protected].

These complete with all hardware, pads etc.

This is $6k in brakes new. I am looking to get $4000 firm + shipping for front and rear.

e-mail with any questions.

Dude--that is a great deal---if someone has the right setup---. Are the rear's 14 inch also?

Thx :) I think so as well! :)

Yep, 14" rears as well.

Thx!

Maaan, an insane deal. I don't see these lasting long. Wish I had $4k.

Pics sent to those who requested them!

I am going to take some better ones tonight as well.

Thx!

Sale pending!!!

thx guys!