DSE Quadralink for 1st gen F-body, Corvette brakes
 

Time to clean things out!

I've got a Quadralink with a powder coated 9" axle housing with Moser 31 spline axles. The the axle housing and axles were run on my car before I switched over to a full floater. They have roughly 5,000 miles on them. The housing is powder coated black. It does have a scratch on it from being towed. If you aren't too picky, you can just touch it up with a little semi-gloss black.

All of the bracketry for the quadralink, i.e. control arms, mounting pockets, etc. are all brand new.

Asking $2,800 for this as is.

If you want a complete kit, that isn't a problem as Best of Show is a dealer for DSE and can provide whatever other parts you would like. Additional parts would sell at retail.

Also up for sale are brakes:
C6 Z06 brakes, front and rear. Powder coated gray. Asking $1200
C6 Z51 rear brakes. These brakes have less that 5 miles of use. I was test driving them when I got hit in the passenger fender: $400
Parking brake assembly for 9" with bracketry for C6 brakes: $300 - SOLD
I will throw in whatever brake pads I have on my shelf.

Will get pictures up soon,

Matt

PM Sent on brakes.

Matt, have pics of the parking brake setup for C6 9"?Will it work with ZO6 calipers?

Pm Sent

Pm sent on DSE stuff

PM sent

Send pics of quadralink and 9" to [email protected]

Thanks

I think I started everyone cleaning out their leftover parts lol! Between you, me and Steve there should be a lot more room in the shop by the end of the week lol! Please take pictures of everything and email to me - lol - j/k. GLWS.

Ok guys, I've gotten a surprising amount of interest today, so after I get pics up, I'll go back and figure out who inquired first and go by times just to be fair.

Here a few pictures, I'll get more tomorrow for the quadralink as most of it is boxed up right now.

http://i366.photobucket.com/albums/o...A/IMAG0275.jpg
http://i366.photobucket.com/albums/o...A/IMAG0276.jpg
http://i366.photobucket.com/albums/o...A/IMAG0281.jpg
http://i366.photobucket.com/albums/o...A/IMAG0282.jpg

Just to answer a few question and clear up a few things, first, the parking brake assembly will work for a 9" but could probably be used on a 10/12 bolt if Tobin will source the correct retaining plates. Second, the parking brake assembly will work for either of the rear brake setups.

Lastly, I never mentioned anything about shipping. All items will ship at buyer's expense. If you're in SoCal we can easily arrange pickup/delivery. I tend to drive around a lot.

Matt

I too am interested in the DSE. Add me to your list and I also would like to see photos.