frame bending question???
 

hello all. i am currently building a 69 charger but have run into rotten frame rails. i have contacted a frame builder about bending new rails which would not be a problem but the distance from where i live is. does anyone out there know of a shop that can bend 2x4 rectangle tubing without having to cut it located around north/south dakota or minnisota? i live in northern manitoba canada and these places would be much closer than washington.
if not then i have no choice but to go with the other shop. oh well.

thanks a bunch
clarence

maybe try Fatman 704-545-0369 ???

Morrison is the only one I know of that can mandrel bend 2 by 4 tubing. it sounds like you already contacted them with reference to Washington.

yes i did contact them. i didnt want to blatantly say that i did as some forum moderators dont like that kinda stuff. anyway thanks for the replies and i will be looking at fatman fabrications.
anymore???
clarence

Is PA close?
 

These guys seem to make everything in house: http://autoweldchassis.com/index2.ivnu here's the link to frame bending: http://autoweldchassis.com/spec.ivnu

--JMarsa

thank you guys. i contacted autoweld and they were excellent to deal with and cheaper than previously qouted. by about 300 bucks!!! i think i will settle on them.
again thank you for the replies guys!!!
ill be back!!!!! and with photos!!!!!!!!!!

clarence

It will be good to hear feedback. I'm not familar with anyone here or at PT that has used them before.

--JMarsa