Mandrel Bent Frame Pieces
 

I found a place that sells Mandrel Bent Square Tubing sections, but now that I would like to order some, I cannot seem to re-find it. Anyone know a source?

Thanks!
Bill

Pretty sure Art Morrison will do that for you Bill.

Here's a couple, I have talked On the Ground in the past but never purchased anything from either but I will soon. :unibrow:

http://www.onthegroundperformance.co...ramerails.html

http://www.autoweldchassis.com/spec.ivnu

I bought 2x4 mandrel bent frame rails from Art Morrison, bent to my specs. Everything came out perfect! I couldn't get Autoweld to return my calls.

This sort of thing, but mandrel bends?

http://www.welderseries.com/blog/onl.../frame-curves/

Ah-ha! Yes!! I now see them on the Art Morrison web page under "new products! Wooohoo! Thanks guys!!

From their website:

http://www.artmorrison.com/store/med.../benttubes.gif

90 Degree Bends for Fabrication
Builders have asked us to custom make small sections of 90 degree mandrel bent tubing for fabricating pieces and parts on a chassis. The "hard way" bends are on the 2" tall section, while the "easy way" is on the wider 4" section. Prices are from $60.00 to $65.00 each. Due to size of item $7.50 box charge added at time of order.
Choose from one of the following once added to cart.
Prices:
(A) 30" Easy-way 2"x4" 90 Degree Bend $60.00
(B) 36" Hard-way 2"x3" 90 Degree Bend $60.00
(C) 36" Hard-way 2"x4" 90 Degree Bend $65.00

Thanks!
Bill

Don't bother with Autoweld.I tried for weeks to get them to get me a quote.They said they were just to busy to quote it.:mad:

Can't go wrong with the folks at Morrison. If they can't do it, it can't be done!

Or you can try Chassisworks


http://www.cachassisworks.com/cac_products.html