easy TKO 500 question
 

Doing a swap in c4 vette ...
What is the electrical plug on the passenger side ? Reverse light sensor ??
Also Two small studs on the drivers side ,what are they for ?
Thanks ...

I'm not one of the mechanically inclined guys and don't know 1/4 of what most of the members here know, but one is the reverse light switch and the other is the neutral override switch that allows you to start the car in neutral without depressing your clutch. Someone else can chime in and let me know if I'm wrong.

Two small studs on the driver's side are for the reverse lights.

I'd have to look at my transmission to see what other connector you're talking about. IIRC, the electric speedo connector is on the tailshaft on the driver's side.

Actually, the electric speedo output is on the passenger side. At least on a 600.

On the one i just installed in a Mopar... Drivers side middle is the reverse lights, pass side is the elec speedo and drivers side on the tail housing next to shifter is the neutral safety switch

Thanks . On my trans the drivers side tail housing just has a plug .
I have a Dakota Digital box for the speedo ..
Ishould be able t figure it out now .

btw ...Took a dana36 out replaced with a dana 44 , out came the 7004 for the tko500
Tilton starter
moved the battery back
four point rollbar ,kirkey seat ( seat might have to wait till next week )
17x11s around
and kumo 710s
QA1 single adustables (rear )
hawk blues
Just a three week thrash ....Autobahn south this Saturday .