9" ford aluminum 3rd member
 

I have a completely rebuilt 3rd member just done by spraker racing 3:80 gear set 31 spline. $1300 set up for road racing. Its in Sarasota, F.L. Call or text (941) 313-6925 shipping $50 in continental us. Thanks Telly
http://i263.photobucket.com/albums/i...ps93a7be55.jpg
http://i263.photobucket.com/albums/i...psdfbd92fe.jpg

9" Inch Third Member
 

What kind of carrier is installed (Trac-Lok, Detroit Locker, etc.)?
Thanks.
Marco

I'll check and let u know. I think a trac loc.

Eaton locker.

hey Telly. PM your best price shipped to 78045. Thanks.

bump, cost me almost 2k good deal here guys.

$1100 shipped in cont. U.s. firm.

Do you know what the pinion offset is?

No! How do I measure it?

not really sure to be honest. I have an Art morrison max g chassis with their housing. I was looking at their website online because i was going to order a Strange 3rd member from them and on their housing spec sheet they want you to specify the pinion offset. Not really sure if it even matters in my case since the floor and transmission tunnel will be built from scratch anways. Is there anybody else out there that can comment to this??