Driveshaft Safety Loop Q's
 

Does it matter where the driveshaft safety loop is placed in relation to where the exhaust crossover pipe (h-pipe/x-pipe) is located?

Is anyone running a loop that attaches to the transmission mount. I don't want to bolt it to the floor boards. The only other option seems to be to use the subframe connector bolts and do a fair amount of fabrication (for an amatuer at best welder). This is for a '67 Camaro.

I haven't drag raced it yet, and I'm not on slicks, so I don't "need" a loop, but the rear end and driveshaft are out right now, so I figured it was a good weekend project to keep me out of trouble.

I think "typical" location is 3/4 toward the rear of the shaft, I imagine to catch it if it breaks at the rear axle. A friend broke the joints at the front of his driveline at 120+, that made a mess of his floor and his underpants!

:thumbsup:
Dan

I would mount it to tword the front of the DS. I'd rather have the rear of the DS hit the ground then the front.. NHRA rules say 6" back from the transmision

Thanks guys, I don't think I was very clear. I know the safety loop needs to be within 6" of the centerline on the front U-joint.

My question was whether there was a rule about where the H-pipe or X-pipe falls in relation to the loop (i.e. does it have to be in front of the loop or behind it, or does it not matter?)

Most rule books specify the DS loop be located no more than 6" behind the front U-joint. If you happen to have sub frame connectors installed that is a good place to mount a DS loop. There is no rule pertaining to the exhaust that I have ever seen.

I think Mythbusters did an episode on the pole vault theory and couldn't make it happen.

I posted a similar question on TC and got the same answer that it didn't matter where the pipe went.

Here's the thread that I was referencing:http://www.camaros.net/forums/showthread.php?t=193442

They mention that the X-pipe has to go behind the safety loop. But in reading it again, maybe they meant it was the only place it would fit, rather than that it was a requirement.

Here are the quotes:

And

Learn something new everyday. Let me ask ya, if its mounted 6" off the front and the rear joint breaks would it hit the ground?

The only loop I've put on is our Studebaker and its more toward the rear. I know that where its located either end can break and neither hit the ground. Just curious.

Dan

Yes, it would still hit the ground, but it would just drag. I think the real fear is that if the front lets go, it could tear up the tunnel and anything (anyone) directly above it.

There's no reason why you couldn't run two loops. One front and one rear, but the NHRA rules require only the front one.

Not to mention, possibly pole vaulting the car ass over tea kettle.