FS: 4.0" bore alum block, crank, rods
 

Item Location (City/State): San Ramon, CA

Price: $80

Description:
2007 truck motor pullout with just over 100K miles. A lifter wheel failed and was making noise which wore out the cam. No damage to the block. All these parts were hot tanked and are super clean now.

4.0" bore alum block with main caps/bolts, crank sensor
(could be honed/reused at this bore, but .005" over preferred by my machinist) $sold
stock 3.622" crankshaft with 58x wheel $80
(needs to cut .010"/.010" due to the journals having scoring on them)
LS2/LS3 style rods with stock 4.0" pistons $200
(skirts look good and very little wear)
lifter valley cover with o-rings $50
rear cover $40
front cover with sensor $80

I can ship anywhere which is additional. Order of preference will be by posting a reply to this thread. Payment must be received within 48hrs or next person in line is up.

Are you asking $80 for the block only?

looks like 700 for the block... Not that it matters that much, but the ly6 is an iron block. 6.0 alu block could be a ls2 with 243/799 cathetral heads or l76 with l92/ls3 heads. GLWS :)

I guess I'm wrong with it being an LY6.... but it is an alum block with the stands/oil holes in the lifter valley.... and it came out of a truck.

L76

http://www.ls-guy.com/l76

Can you get me a shipping quote to 92808.

I'm looking for the block only. Did you take the heads off? If you did, will you please post a pic of what they looked like.

I can ship the block to Forward Air trucking depot and you pick up for about $100. If you need delivery to your door add another $90. (lift gate fee, residential fee)

Forward Air trucking depot
18055 HARMON AVENUE
CARSON , CA 90746

I bought it as a shortblock. The heads are on the new shortblock that went back in the truck.

block sold