tru turn Help
 

I have an email out to the guys at ridetech with these pictures but i was wondering if anyone else had this issue. The large stud tie rod does not go all the way up into the steering arm. I also can not fit the cotter pin on the top either. it is the same on both driver and passenger side

https://im1.shutterfly.com/media/47a...D720/ry%3D480/

I think you used the drag link stud instead of tie rod

Thanks for taking a look, I thought that at first also but it is the tie rod for sure, I already mounted the drag link successfully.

Photo
 

Something is not quite right. Here is a photo of mine.

http://i.imgur.com/dH26iV0l.jpg

Scott

Thanks Scott, defanitley something off, looks like my weekend plans of wraping this front end up have changed to doing leaves instead :bang:

pull it back out and see if the tapered hole isn't reduced by powder coat, burrs or just plain out of spec.

Thanks all, the team at ridetech is taking care of it and sending me new arms with the studs installed to make sure they fit correctley.

Awesome! Good people there.

That's some amazing customer service!

Did you get everything fixed, Paul?