Lateral-g Forums

Lateral-g Forums (https://www.lateral-g.net/forums/index.php)
-   Wanted/WTB (https://www.lateral-g.net/forums/forumdisplay.php?f=46)
-   -   Looking for a SBC mild build complete (Nor-cal) (https://www.lateral-g.net/forums/showthread.php?t=55582)

glassman 10-08-2017 11:04 AM

Looking for a SBC mild build complete (Nor-cal)
 
Like the title states, i'm pulling the Olds out of my Keaton and going sbc, much cheaper to run and get parts for. I figure with the number of LS swaps out there someone may have one laying around. Looking in Nor-cal, trying here first, don't really want to buy new or deal with c/l although i might...

Boat doesn't get used much and not sure if i want to sell, right know the Olds is bad (the shop who did the three angle grind a few years back used wrong head gaskets, long story. I didn't pay all the bill due to other unmet "promises" on their part). High quality shop too, but they only wanted to work on the "big boy boats" of which mine is not.

Cheers, mike

SSLance 10-08-2017 02:56 PM

Pm sent

ADY 10-08-2017 05:22 PM

Buddy of mine just did an LS3 swap from a 383 sbc with a Holley TBI setup this past summer. It might still be sitting at West Coast Muffler in Concord. It was swapped out b/c it was burning oil after a fresh rebuild and he was fed up and just wanted a stock crate motor.

ADY 10-08-2017 06:14 PM

Sorry, should have asked before posting... the SBC is already sold. Good luck!

Panteracer 10-09-2017 11:50 AM

Small block chevy
 
Mike,
I don't have a chevy but do have a couple of Pontiac engines
will bolt in place of the Olds engine

455 fairly stock with new crank and cam.. $3200 no dizzy,carb or manifold

428 actually 440 with steel crank, killer rods, polished manifold, ported
#16 heads.. cam was flat so new cam, lifters and bearings $4200

I can send flyers if you are interested

Bob- Panteracer and Dreamin Tas

Panteracer 10-09-2017 12:31 PM

Small Block Chevy
 
Mike,
I do have a fairly stock small block
with a high rise, new edelbrock carb,gear drive,
recently rebuilt.. It is in my 63 truck I
bought and I am toying with putting one
of the Pontiac engines in it.... you can hear
it run....

$1500 for the chevy

Bob- Panteracer

glassman 10-10-2017 12:42 PM

thanx Bob, i dont think the pontiac head will sync with the olds, and at 1500-2000 exhaust, it wouldnt deem itself cost effective.

May be interested in the chevy though.....thanx

Panteracer 10-10-2017 01:33 PM

Small Block Chevy
 
Got it...
Let me know if you want to hear or see the chevy
I could maybe meet you some place or you can come
to my shop in Campbell.. thinking one of the Pontiacs
is going in the truck

Bob


All times are GMT -7. The time now is 03:06 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2026, vBulletin Solutions Inc.
Copyright Lateral-g.net