Need more info/dimensions on ATS Camaro spindles
 

Looking for some dimensions and bearing load info on the 1st gen camaro ATS spindles. I like the idea of them and they look like a great product, but for me to jump and buy them I need to know that they fit my goals rather than just "improves negative camber gain". The car they're going on is a fairly hardcore street/race car, not too many comforts, and will be total build from scratch suspension wise. I plan on analyzing my geometry using LOTUS Shark, so it would be greatly appreciated if someone could get me these distances and caster, or at least equivalent KPI and caster.

the kpi is 8 deg
the cl of hub to ubj is 6.81
the cl of hub to lbj is 4.02
hub face to ubj is 7.2
i do not have hub face to lbj

don't understand the caster question?

Was going to tell you ask speedtech being as they're the manufacturer but , you got the man himself already answering everything for you , good luck

That's awesome I appreciate it. By caster I meant if there was any built in offset from the sideview between upper and lower balljoints, but looking at pictures of them I don't think there is.

I should have been more specific, but those numbers you gave me were the center of the balljoint, or the center of the hole where the balljoint bolts in?

ball joint center

Awesome, Thanks again!