LS9 pinout help
 

Looking for a little help on the ECM wiring. On Service Information schematics it shows on connector X2 pins 2, 68 and 69 should be PU/WH, GY/WH and GY/WH for the bank 1 and sensor 1 low signal and B1S1 heater control circuit and B1S2. That’s all good until I try to wire the crank sensor. It shows the crank sensor should be in those terminals as well. Anyone have a good schematic that can tell me what one goes there and where the other is supposed to go?

Looks like the crank is wrong in the schematic and should be terminals 27, 43, amd 63 if anyone can confirm.

Awesome, thank you.